TV aerial installation cost depends on the work required at the property, not a postcode-wide price band. Mounting position, access, measured signal, the condition of existing equipment, cable routes and the number of TV points can all change the scope. This guide explains those factors so you know what information a quotation should include.
Common TV aerial installation scopes
- Loft aerial: considered only where measured reception, roof construction and the available mounting position make an internal installation suitable.
- Wall-mounted external aerial: requires a suitable fixing point, safe access and a planned weather-sealed cable entry.
- Chimney-mounted aerial: scope depends on safe access, the condition of the stack and existing hardware, and the mounting and cable route required.
- Combined or more complex distribution: additional TV points, amplification, filters or mixed Freeview and satellite work are specified from the measured requirement.
- Communal or MATV systems: surveyed and quoted for the building rather than treated as a domestic single-aerial job.
What changes the quoted cost?
Measured signal at the property
We measure the usable signal before choosing the aerial and distribution components. Nearby properties or a general coverage map cannot confirm the correct aerial, mounting position or need for amplification at a particular address.
Mounting position, height and safe access
A reachable wall position, loft, chimney, dormer or restricted rear elevation can require different access equipment and working time. The quotation should state the intended mounting position and any access assumption rather than hiding it in a headline price.
Existing brackets, poles, cable and equipment
Serviceable equipment may be retained where appropriate. Corroded fixings, damaged cable, unsuitable splitters or an unsafe mount can add replacement work, but they should be identified and agreed rather than automatically replaced.
Cable route and making good
Cable length alone does not describe the job. External routing, wall entries, loft access, concealed routes, weather sealing and the position of the final outlet all affect the scope.
Number of TV points and distribution design
One outlet is different from distributing a measured signal to several rooms. Extra points may require a suitable splitter or amplifier, power and additional cable routes; these should be shown separately in the quote.
What an EDD quotation should set out
- The fault or requirement being addressed
- The proposed aerial, mounting position and access method
- Which existing equipment will be retained or replaced
- The agreed cable route, outlets and distribution equipment
- Testing, tuning and making-good work included in the scope
- The applicable parts-and-labour guarantee
- A fixed quoted price for the agreed scope and any stated exclusions
Get a quotation for the actual property
Call 0161 399 1757 or send photographs on WhatsApp for an initial discussion. Photographs can clarify the visible equipment and access, but measured reception or hands-on diagnosis may still be needed before the final scope is confirmed. We explain any diagnostic charge before chargeable fault-finding starts.
See our TV aerial installation page, TV aerial repair service and communal aerial systems page for the separate service scopes.
Clear written quotation before any chargeable work. Short-notice appointments may be available across Stockport, Greater Manchester and Cheshire.